ASTM A833-19 《用对比硬度计测试金属材料压痕硬度的标准试验方法》美国标准(英文版)_硬度标准_技术_沈阳天星试验仪器股份有限公司
ASTM A833-19 《用对比硬度计测试金属材料压痕硬度的标准试验方法》美国标准(英文版)


Standard Test Method for Indentation Hardness of Metallic Materials by Comparison Hardness Testers 




This standard is issued under the fixed designation A833; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.


1 This test method is under the jurisdiction of ASTM Committee A01 on Steel,Stainless Steel and Related Alloys and is the direct responsibility of Subcommittee A01.13 on Mechanical and Chemical Testing and Processing Methods of Steel Products and Processes.

Current edition approved Nov. 1, 2019. Published December 2019. Originally approved in 1984. Last previous edition approved in 2017 as A833 – 17. DOI: 10.1520/A0833-19.

2 For referenced ASTM standards, visit the ASTM website,, or contact ASTM Customer Service at For Annual Book of ASTM Standards volume information, refer to the standard’s Document Summary page on the ASTM website.

替代情况:替代ASTM A833-17


1. Scope

1.1 This test method covers the determination of indentation hardness of metallic materials using comparison hardness testers.

1.2 This test method applies only to those portable comparison hardness testers that use test bars that have been standardized according to Test Method E10 as a basis for comparison.

1.3 Calibration of test bars, used for comparison to determine hardness numbers, is also covered by this test method.

1.4 The impression force used during comparison hardness testing is normally an impact load applied by striking a hammer on the appropriate areas as outlined in the manufacturer’s instructions.

2. Referenced Documents

2.1 ASTM Standards:

A370 Test Methods and Definitions for Mechanical Testing of Steel Products

E10 Test Method for Brinell Hardness of Metallic Materials

E177 Practice for Use of the Terms Precision and Bias in

ASTM Test Methods

E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

在线阅读            免费下载
contentHeight = $(".newsContent").height(); if(contentHeight < 615){ contentHeight = 615; }