ISO 14577-3:2015 《金属材料 硬度和材料参数的仪器化压痕试验 第3部分:标准块的标定》国际标准(英文版)_硬度标准_技术_沈阳天星试验仪器股份有限公司
ISO 14577-3:2015 《金属材料 硬度和材料参数的仪器化压痕试验 第3部分:标准块的标定》国际标准(英文版)

INTERNATIONAL STANDARD ISO 14577-3ISO_14577-3_2015.png


Metallic materials — Instrumented indentation test 

for hardness and materials parameters — 

Part 3: 

Calibration of reference blocks


ISO 14577 consists of the following parts, under the general title 

Metallic materials —— Instrumented indentation test 

for hardness and materials parameters 


ISO 14577-1:2015, Metallic materials — Instrumented indentation test 

for hardness and materials parameters — Part 1: Test method

ISO 14577-2:2015, Metallic materials — Instrumented indentation test 

for hardness and materials parameters — Part 2: Verification and calibration of testing machines

ISO 14577-3:2015, Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 3: Calibration of reference blocks

ISO 14577-4:2016, Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 4:Test method for metallic and non-metallic coatings


Contents


Foreword

Introduction

1 Scope 

2 Normative references

3 Manufacture of reference blocks 

4 Calibration machine

5 Calibration procedure

6 Number of indentations

7 Uniformity of hardness

8 Marking 

9 Validity 

Bibliography


1 Scope


This part of ISO 14577 specifies a method for the calibration of reference blocks to use for the indirect verification of testing machines for the instrumented indentation test as specified in ISO 14577-2:2015.

NOTE  The reference blocks can be calibrated in accordance with the field of application of the testing machine or with the materials parameters which are being determined.


2 Normative references


The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

ISO 376, Metallic materials — Calibration of force-proving instruments used for the verification of uniaxial testing machines

ISO 4287, Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters

ISO 14577-1:2015, Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 1: Test method

ISO 14577-2:2015, Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 2: Verification and calibration of testing machines




在线阅读            免费下载
contentHeight = $(".newsContent").height(); if(contentHeight < 615){ contentHeight = 615; }